會議：第十二屆亞洲紡織會議暨2013中國紡織學術年會

時間：2013年10月24-26日

地點：上海東華大學

分會場：現代紡織裝備技術

報告題目：噴氣渦流紡噴嘴模型——同心圓管內切向引射旋流結構初探

報告人：裴澤光

報告英文簡介：

nserted inside the groove of sewing needle and ambient factors like room humidity and temperature impact is measured for the heating of sewing needle. The Lock stitch machine (Brother, DD7100-905) is run at its maximum speed of 4700RPM with stitch length of 14 SPI and temperature of needle is measured by thermocouple inserted inside the groove of needle to measure needle temperature for a maximum of 60 seconds of sewing.2/1 twill 100%cotton denim fabric with 257GSM with two layers were used and it was observed that with the increase of relative humidity there is insignificant increase of sewing needle temperature but still Use of fan for cooling causes a decrease of sewing needle temperature at higher relative humidity level. Whereas the needle temperature rises with the increase of ambient temperature. At sewing floor the ambient temperature must be set carefully to keep the sewing needle temperature low. The article is useful for knowing the impact of ambient temperature and humidity on sewing needle temperature.